Hikvision Digital Technology DS-2AE5154-A User Manual download pdf (Page 34)

User Manual of E Series 5-inch Speed Dome

3. Configure the zone area.

Steps:

(1) Move the cursor to EDIT ZONE and click IRIS+ button to enter the edit mode.

(2) You can see SET LEFT LIMIT on the screen. Click the direction buttons to set the left limit

stop.

(3) Follow the prompts on the screen to set the right limit, up limit and down limit.

(4) Click IRIS+ button to save the settings and exit.

4. Set the zone status and scan status.

ZONE STATUS: The zone status just indicates the current status of the zone.

SCAN STATUS: You can set the scan status to ON/OFF to enable/disable the scanning in the

zone.

Note: ZONE STATUS is not editable. After you edited the zone, it will switch to ON automatically;

if you delete the zone, the ZONE STATUS will switch to OFF.

5. Clear the zone settings.

Move the cursor to CLEAR ZONE, click IRIS+ to clear all the settings of the current zone, and click

IRIS+ again to confirm the settings and exit.

3.4.7 Clearing PTZ Control Settings

Purpose:

You can clear all user-defined PTZ control settings, including presets, patrols, patterns, zones and

time tasks. You can also clear privacy masks on this menu.

Steps:

1. Enter the CLEAR SETTINGS menu:

MAIN MENU > DOME SETTINGS > CLEAR SETTINGS

CLEAR SETTINGS

CLEAR ALL PRESETS

CLEAR ALL PATROLS

CLEAR ALL PATTERNS

CLEAR ALL BLANKS

CLEAR ALL ZONES

CLEAR ALL TIME TASKS

BACK EXIT

Figure 3-21 Clear Dome Settings

2. Move the cursor to each item, e.g., CLEAR ALL PATTERNS, and click IRIS+ to enter the

corresponding submenu. Click IRIS+ again to confirm the settings and exit.

On DIAGNOSTICS submenu, you can see the self-diagnostics information of the speed dome. For

more details, please refer to the table below.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 43 44

No comments

Hikvision Digital Technology DS-2AE5154-A User Manual Page 34